BBK 1737 Cold Air Intake System - Power Plus Series Performance Kit for Ford Mustang 4.0L V6 Chrome Finish

Like others mentioned, after installing and driving for a few miles the check engine light came on and stays on.2010 Mustang.Had to install new mass flow air sensor from O'Reilly.. AutoZone part didn't fit. It's been working fine with no check engine light. Something about this aftermarket part doesn't like the OEM air sensor.*Use lock washers on screws or you'll bottom out or snap the OEM screws. BTW, BDK customer service was no help and didn't receive a call back, they need to better engineer this part. After the back and forth, finally satisfied.

It was easy to get the stock system out but getting this thing in was a bit harder than the videos made it seem. I ended up needing a second set of hands. All in it took about an hour. Don't forget to disconnect the battery either or you'll get the check engine light. Easy fix if you miss that though.Once it was in I took it for a test drive. The sound is great compared to the stock system, the power difference is notable-not too much but you feel it. And after two weeks of having it in I have noticed that I fill up the tank a little less.

When sent to me it appeared to be just thrown in the box with no bubble wrap or styrofoam. Not only that it was also dirty on the inside of the part. I bought it brand new so there is no reason for these thing to have been this way. Oh yeah and the part was defective. I assume they had already had the part returned by someone else because it was defective so they decided to resell it knowing full well it was not going to work.

Nice intake, good directions and decent fit on 2005 mustang v6 4.0L SOHC. This purchase was inspired by an aftermarket K&N intake that had a massive 4.5" filter that not even my mechanic could get back on (filter seal too small). I would give the system itself 5 stars but for the following small issues in the frame design:-frame rattles against shock/strut well (easily muted by rag slid under intake frame)-filter can be a little tricky to remove for cleaning but much easier than my previous K&N setup-secondary bolt hole secured by plastic fastener in radiator cover, would rather have bolted to existing stock filter brackets.All together, I am pleased with this purchase and would recommend to anyone with a stock or frustrating aftermarket setup. No way I would spend $250-$300 for a few horsepower, BBK system was a welcomed improvement for a much friendlier price. Makes the rest of my engine look rat bag filthy!

IT is not as easy to install as you might think . No instructions unless you visit the. "web site" that sucks . No explanation of the various parts . Didn't mention you had to take the radiator cover off and remove the bracket that holds in place > This to secure the heat shield . A ribber gasket you dont need for the air filter cone and a rubber gasket that one has to customize to make it fit. The whole thing was a bummer . Looks nice when done but a real PITA to instal....

Mass air flow sensor adapter was installed upside down and the intake would not work. Had to argue with the seller to get a full refund but they did come through with the refund.

I purchased my 2010 V6 Mustang and the first thing I did was add the BBK Cold Air intake. It breathes so much better, giving me additional horsepower, and a bit better average fuel mileage, when I keep my foot out of the gas. The install was simple, with the directions giving clear counsel as to how you install. If you know how to use a screwdriver, then you should be able to install in one hour or less. Simply follow the numbered instructions, be patient, and within one hour your Mustang V6 will become a horse of a different color.

I purchased this for my 2010 Mustang 4.0 V6. The installation was easy & quick, but make sure you install the included rubber molding around the shield where it could come into contact with the fender. At a low rpm launch with a standard it will vibrate, and without the rubber cushion you'll hear it. Overall I'm very pleased with the product and recommend it to anybody that wants to dress up their engine and gain a little more performance. Great quality at an affordable price. I've probably put over 1,000 miles on it since installing and haven't had any check engine issues.